Mobile ally welder
Submitted by Stevo81 on Tue, 2015-07-21 07:51
Hey fellas need to get a couple of ally rod holders welded to the rocket launcher. Was hoping it could be done at my place, without removing the rocket launcher as its through bolted to the hardtop and I wanted to maintain factory seal if possible.
Would it be possible to protect fibreglass hardtop and deck from damage with welding mats etc or should I just remove it and take to a fabrication shop?
Any mobile ally welders NOR ocean reef area?
" rel="nofollow">
" rel="nofollow">
" rel="nofollow">
" rel="nofollow">
" rel="nofollow">
____________________________________________________________________________
•••••••• Electrical Contractor NOR ••••••••
epic restos and...
Posts: 226
Date Joined: 22/06/15
blankets
covering the boat will be fine and get them tiged up so there is no damage done
Walfootrot
Posts: 1385
Date Joined: 23/07/12
Are you sure its ally? looks
Are you sure its ally? looks like SS in the photo
More drum lines, kill the bloody sharks!
Ericl
Posts: 476
Date Joined: 02/05/11
Aluminium
I reckon it is Anodised Aluminium
Don't spend all your money on beer, boats, and fishing. Save some to spend foolishly
Stevo81
Posts: 1278
Date Joined: 16/04/12
Yep, anodised ally
Yep, anodised ally
•••••••• Electrical Contractor NOR ••••••••
epic restos and...
Posts: 226
Date Joined: 22/06/15
yep its alley and if I was a
yep its alley and if I was a betting man I would say the tube thickness would be around 1.3 mm wall so tig it
bellony
Posts: 94
Date Joined: 27/01/10
Tig will require minimum of
Tig will require minimum of 15A power supply. Bigger better welders will be 3 phase so I would take it to the workshop. To get a strong neat job I would remove the bar from the roof, no risk of heat transfer damaging the fibreglass then, and also gives the guy welding better access to control the angle for better penetration. Also if the anodising is sanded back to clean ali before welding you will get a much better weld.
Stevo81
Posts: 1278
Date Joined: 16/04/12
Thanks for the info guys,
Thanks for the info guys, cheers
•••••••• Electrical Contractor NOR ••••••••