Trailer Repairs
Submitted by bsir on Tue, 2020-12-15 11:36
Ive just replaced all the bearings on my boat and in doing that noticed somebad rust on the cross beams (box trailer).
Stupidly i gave them a tap and discovered they are pretty crap (I stuck a hole in one of them).
Im ringing around looking to see where i can get a new trailer (ideally thsi week), but dont like my chances (7m, 3.2-3.5T).
Anyone know anywhere that can do a repair by replacing a few cross members? Im guessign this would screw any galvenising, but open to suggestions.
Thanks
dodgy
Posts: 4578
Date Joined: 01/02/10
What trailer is it? Can buy
What trailer is it? Can buy pre galvanised replacement sections for dunbier in Perth. Far cheaper to replace a couple of cross members than a whole trailer.
Does anyone know where the love of god goes, when the waves turn the minutes to hours?
bsir
Posts: 574
Date Joined: 24/04/11
Mayfair marine
Its not a dumbier, but i might hit them up for some bolt on sections (although i doubt they would fit)
dodgy
Posts: 4578
Date Joined: 01/02/10
Well that's a pain. Mayfair
Well that's a pain. Mayfair do sell the sections too but pretty sure they don't have an agent over here. I did email them and ask for one of my trailers but they never got back to me. And their website is hard to use.
Does anyone know where the love of god goes, when the waves turn the minutes to hours?
tiimmbo
Posts: 695
Date Joined: 16/08/09
Fremantle trailers did my
Fremantle trailers did my rebuild and were very good.
bsir
Posts: 574
Date Joined: 24/04/11
Thanks Timmbo
I spoke with them, they can look at it mid/late January. Thats an option for me.
squidvicious1
Posts: 824
Date Joined: 22/07/10
Tezza's trailers in port
Tezza's trailers in port Kennedy.!!!
squidvicious1
Posts: 824
Date Joined: 22/07/10
Tezza's trailers in port
Tezza's trailers in port Kennedy.!!!
bsir
Posts: 574
Date Joined: 24/04/11
New
Can get a new one from them, not bad price, but not until April next year.
Prego
Posts: 136
Date Joined: 03/06/09
SoR try Sheet Metal Fabricators
Wellard St, Bibra lake.
They built mine then galvanized.
Prego
Posts: 136
Date Joined: 03/06/09
SoR try Sheet Metal Fabricators
Wellard St, Bibra lake.
They built mine then galvanized.