BEP Dual battery switch question
Submitted by Adonis on Fri, 2012-11-30 08:23
Hi guys,
Fitting up a dual battery switch this weekend, had a sparky mate who was going to give us a hand but looks like I might be doing it alone.
Question is I don't understand the wire labelled dual sense vsr on the wiring diagram! I understand the rest of the diagram but the dual sense vsr wire, where does that go to and where am I supposed to connect it? Also on the diagram the thing it's connected into, is that a connector strip or fuse strip??
Any help would be much appreciated!
Cheers!
Starbug
Posts: 563
Date Joined: 27/08/09
thats your common conection
thats your common conection point/conector block for all your negative wires. So if you have a "dual sense" VSR, you run a wire forn the VSR to the negaitve comon point.
Adonis
Posts: 53
Date Joined: 02/06/06
Cheers starbug, so in that
Cheers starbug, so in that case the switch will be back near the batteries I could just run the wire straight to a negative terminal on one of the batteries?
Starbug
Posts: 563
Date Joined: 27/08/09
The remote sense wire is to
The remote sense wire is to compensate for volt drop in the wiring from your battery negative to your negative common connection point. For best operation connect it to the negative block.
Adonis
Posts: 53
Date Joined: 02/06/06
Ah I see, thanks very much
Ah I see, thanks very much for the helpful info mate legend!