Changing out Bennett Hydraulic Actuator
Submitted by Mitch88 on Mon, 2016-07-25 07:05
One of my actuator needs changing out.
Is it a straight swap bolt on bolt off or will the system require bleeding?
Anyone changed one out?
Mitch
Rob H
Posts: 5807
Date Joined: 18/01/12
If you cant find the info by
If you cant find the info by googling, go onto The Hull Truth and contact Tabman (Tom)
He works for Bennetts and is a legend on there dealing and advising on these.
But I would imagine youd need to bleed but I think its just a matter of cycling them a few times
Give a man a mask, and he'll show you his true face...
The older you get the more you realize that no one has a f++king clue what they're doing.
Everyone's just winging it.
pricey10
Posts: 486
Date Joined: 07/01/12
Bolt off bolt on mate. Fill
Bolt off bolt on mate. Fill it up with atf oil and just run them up and down a few time it will bleed ot self. Thats all i did
Karratha. WA
Mitch88
Posts: 181
Date Joined: 23/09/14
Thanks for the help :)
Thanks for the help :)
boora
Posts: 43
Date Joined: 10/02/13
Actuator help
Not sure if you are experiencing same problem but one of my Bennett actuators started leaking. I purchased o rings from local boat dealer (Midway Marine) in Rockingham then emailed Tabman Tom through Hulll Truth as mentioned by Rob H. Within 24 hours I had a reply from Tom with instructions on how to fit the o-rings. PM me if this helps as I can email you the instructions.