Northstar transducer

Hi Guys, great forum with loads of great info, only browsed so far but joined today.

I have a Northstar Explorer 660 combo plotter/sounder which was working fine up until a couple of weeks ago. The sounder has stopped working, I have checked the connections at the display unit. Is there anything else that can be done to troubleshoot before I try and hunt out a new transom transducer? I know Northstar no longer exists so may not be that easy to find a replacement.

Looks like I will need to replace the transducer but want to see if there is anything I should check first?

Any advice greatly appreciated!


Posts: 198

Date Joined: 25/05/10

Have you checked that the

Mon, 2012-03-26 16:46

Have you checked that the sonar has not been turned off in your settings by mistake, cleaned plug end with a tooth brush and crc. Transducers are normally the least likely end of the unit to break. 

What doesnt work with it?

Rod P's picture

Posts: 725

Date Joined: 20/05/08

SR 20 normally when the

Tue, 2012-03-27 12:09

SR 20 normally when the sounder is on the transducer will click. I find the transducers fairly bullet proof unless wires are cut somehow. I actually have a through hull transducer that would work well in your boat. Cheap (if you have a SR20)

If your interested let me know on 0412217757

 

Posts: 3

Date Joined: 20/03/12

Thanks for the comments guys.

Wed, 2012-03-28 11:30

Thanks for the comments guys. I already checked plug connector, but will double check and clean again this weekend to make sure.

Rod, yes boat is a SR20 - might give you a call about that transucer if i'm still having no luck!

 

Posts: 3

Date Joined: 20/03/12

 Cleaned all the pins and

Sat, 2012-04-14 20:07

 Cleaned all the pins and connections, can hear the transducer clicking quietly, did a factory reset of the unit.....not sure what else to try!!

Any ideas very much appreciated!

 

Rod P's picture

Posts: 725

Date Joined: 20/05/08

If its clicking i think its

Mon, 2012-04-16 13:21

If its clicking i think its working. Have you tried to turn up the gain or sensitivity.

 

If your near Joondalup you can bring  the unit down and we can plug into a couple of different boats and compare that way.