Transducer on chivers sports fisherman
Submitted by Fresh herbs on Sat, 2022-01-29 20:42
Hey guys. Just wondering if anyone has installed a airmar P66 transducer. I've just bought a 588 furuno and installed the transducer as per instructions and I can only get ground up to about 10knts. Anyone had any joy with their install and can get a good reading? Tips please. Cheers herbs
dale 308
Posts: 156
Date Joined: 06/04/12
P66
My p66 is buried alot deeper than it says too and a bit more angle than recommended but it holds bottom and 35+ knots so just start by dropping it down in 5mm increments play with angle but only do 1 change at a time
Jackalchub
Posts: 599
Date Joined: 10/03/12
Adjust lower mm by mm.. the
Adjust lower mm by mm.. the compromise will be a rooster tail.. can get a splash guard if that bothers you
little johnny
Posts: 5362
Date Joined: 04/12/11
Mine inch
Below hull. Facing forward by 5 mm. Great readings no rooster tail
Fresh herbs
Posts: 34
Date Joined: 11/01/19
Did you use some sort of
Did you use some sort of mount to get it that deep?
eziliving
Posts: 876
Date Joined: 30/12/09
yep i ended putting mine in
yep i ended putting mine in deeper than recommended on my old boat and mine would read the ground at 30knots.
Get busy living, or get busy dying!
eziliving
Posts: 876
Date Joined: 30/12/09
yep i ended putting mine in
yep i ended putting mine in deeper than recommended on my old boat and mine would read the ground at 30knots.
Get busy living, or get busy dying!