navionics not showing properly
Submitted by crano on Sun, 2017-01-15 18:37
Got an HDS 5 gen 1 GPS today and put my navionics card in it but it only shows depths and contours out to what ever safety depth the unit is set for. The maximum safety depth is 20m so anything deeper then that does not show. Any ideas [and yes I have updated the software]?
crano
Posts: 704
Date Joined: 04/11/09
fixed
Had tried all settings and no good but restored factory settings and it was OK
sea-kem
Posts: 15002
Date Joined: 30/11/09
Was the factory restore in
Was the factory restore in the settings Crano or did you have to push a couple of buttons for a soft reset? Just for future referrence is all.
Love the West!
Jackfrost80
Posts: 8147
Date Joined: 07/05/12
.
.
Officially off the Pies bandwagon
crano
Posts: 704
Date Joined: 04/11/09
Restore factory defaults
Tried a soft reset that did nothing Restore defaults is in the menus.
sea-kem
Posts: 15002
Date Joined: 30/11/09
Cheers mate, I have the HDS
Cheers mate, I have the HDS 9 and no issues as of yet. So good for future referrence. I had an older model Lowrance and was constantly having to do soft resets, one time all my marks disappeared. Fun times.
Love the West!
snappermiles
Posts: 2100
Date Joined: 05/11/10
card
try removing the card and putting it back in. my hds 7 used to do that. then try updating it if it doesnt work
ALL FISHERMEN ARE LIARS EXCEPT YOU AND ME! AND IM NOT SO SURE ABOUT YOU!