Fcv295 trans wiring
Submitted by RobertMc on Wed, 2016-12-28 20:45
Hey guys, does anyone have any info on wiring the tranny into the back of the 295, iy seems i have 2 wires and 3 possible locations, if anyone has any info it would be much appreciated.
scottnofish
Posts: 1621
Date Joined: 28/08/07
Google furuno transducer matrix
Has all the tappings
RobertMc
Posts: 326
Date Joined: 19/01/09
Cheers scott, i am aware of
Cheers scott, i am aware of the tap settings and the jumper wire, but i cant find any info in regards to which position the trans plugs into the head unit.
Cheers mate
Ashram
Posts: 134
Date Joined: 23/10/09
Placement
One transducer or 2? There is a high frequency and low frequency block that you have to use. Depends on transducer what you do though. Both are marked with either LF or HF.
RobertMc
Posts: 326
Date Joined: 19/01/09
hi ashram, at the moment mate
hi ashram, at the moment mate i am just running a LF transducer it is a 3kw 28khz transducer, it has a black and a white wire, i will be running a 2kw 200khz as well but for now just a LF, i can see there is a lf block and hf block, just unsure which wire goes where as each block has 3 x possible locations where it can go?
Ashram
Posts: 134
Date Joined: 23/10/09
WAGO Connector
You put them in the LF Wago connector in hole 1 and 3 doesnt matter which way round. The sheild is pulled back and clamped with the bracket that holds transducer cable to the back of the unit. Make sure you set you tap settings for the transducer too.
Cheers