hi guys

hoping someone on here can help???

im casing someone who can ally weld, you will also need to be able to bend som 25mm ally pipe.

bellow there is a image of my rack

i want to extend the width and lenght of the top rail on my roof rack so i can carry a dingy, proberly 4" all the way around and then attached with flat bar at the top/side of the origanal side supports coming down on a 45 degree angle to the bottom roof rack tube.

 i can then screw some of that blue slide stuff to the flatbar.

i can email you some very rough drawingings of what i want, but i think you would get where im going with this

if it was steel i could do it myself, i can not run ally through my welder!!

i can pay cash, take you fishing or both, what ever you want.

i work away on 4/1 roster so you can have 4 weeks to do it, even 2 swings if need be, of course the roof rack will be off the car!!

the rack is a copy of the arb/tracklander full lenght ally rack of a 100 series cruiser

pm me your number and i can call you or i will pm you my number

thanks in advance 

Ron