lost all chart detail on HDS 10
Submitted by black gen on Tue, 2019-05-28 07:18
may be something simple, but i have a navionics card in my HDS 10 gen 2.
i have lost all chart detail, all my spots still there but no detail or contours to speak of.
could it to do with the firmware? Im scared to update it in light of the problems over the last 6 weeks with the GPS rollover date
anyone have any ideas
cheers
bennym_82
Posts: 86
Date Joined: 18/05/16
Lost chart
Have seen this before on a unit that wasn’t registering the chip was installed. Closer inspection showed that there was some light corrosion on the contacts. Cleaned off card and plotter points as best as we could and card started working again. This was on a gen 1 HDS. Not sure if this will be your issue but something to look for.
If the card isn’t registering in the unit I think you may be able to check as on the navigation page menu, you should only have lowrance chart as an option with navionics chart option missing??
bennym_82
Posts: 86
Date Joined: 18/05/16
Double post
double up
RobertMc
Posts: 326
Date Joined: 19/01/09
for a starting point get a
for a starting point get a SD card and back up your waypoints, which everyone should do regularly anyway, then check that the Navionics map is selected, not the lowrance Map, if navionics is selected try to reset the unit or try someone elses map card.
sunshine
Posts: 2600
Date Joined: 03/03/09
Did you run over a black cat
Not your week mate
black gen
Posts: 762
Date Joined: 13/04/11
hahaha sunshine.This card
hahaha sunshine.
This card issue has been like this for maybe a year ive just been to lazy to do anything about it.
its not an issue i just wouldnt mind the maps back.
keg
Posts: 398
Date Joined: 17/07/07
same here
my hds9 was doing the same thing and it was the door that closes over the navionics card that was
hitting the card and making it lose contanct. i had to bend the door a little bit to stop it hitting the card
when closing it.
black gen
Posts: 762
Date Joined: 13/04/11
there is some rust or
there is some rust or marking on the inside of the cover, that may be causing soem of the problem in getting a good contact.
Thanks for the heads up all
scubafish
Posts: 962
Date Joined: 15/08/12
New updates for gen 1 are ok.
Do back up first.
Check to see if your sd card has a mini sd in it ,if so take mini out and put it in new large one,then try again.
http://img.gg/BQ91Sys