Rod building video
Submitted by Bunny on Sun, 2016-01-31 07:14
I'm in the middle of making a rod for a mate. Thought I would GoPro the making of the pattern.
Now edited with the second clip.
https://m.youtube.com/watch?v=n86jFiKyXPs
sunshine
Posts: 2626
Date Joined: 03/03/09
Expletive........you make it look so easy
And I have tried and successfully tied fancy wraps but that was manic.
i am surprised at how untidy your work bench is but that is perhaps a reflection of being brought up by an anal engineer where everything had "it's" place OR ELSE
Bunny
Posts: 678
Date Joined: 05/08/10
No your right. It's terribly
No your right. It's terribly messy. I thought about cleaning it up but that would be faking it! I'm shocking.
I just locked off the end bits so will post that soon. I put a towel down to hide the rubbish lol.
sstevee
Posts: 472
Date Joined: 15/11/11
Awesome wrap! Just out of
Awesome wrap!
Just out of curiosity, what does a turning machine like that set someone back?
Bunny
Posts: 678
Date Joined: 05/08/10
A few hundred dollars and up
A few hundred dollars and up from there. You'll notice I didn't use the motor though. I just lock the rod in and take advantage of the clutch stopping the rod from turning backwards and unwinding the thread. You'll be surprised at how handy that is. When I do the locking bits and guide wraps it is invaluable over a manual method.
Cruise Control
Posts: 973
Date Joined: 03/11/10
Wow - I've done a few wraps
Wow - I've done a few wraps and they were absolutely painful. Looks like the benefit of the machine locking up and leaving you with a free hand is invaluable. Nice work.
opsrey
Posts: 1200
Date Joined: 05/10/07
Nice.
very good effect.
sstevee
Posts: 472
Date Joined: 15/11/11
Heck yea! I'm personally
Heck yea! I'm personally loving these vids.... Problem is fishing is already an expensive hobby and i'm getting ideas, haha