Sounder advice

 I purchased a furuno gp1971f around Xmas time and installed it myself I have run the tranny leads under the deck away from other electrics but have got my power from the bus bar under the dash. I get a good clear picture when running every now and then I do loose the bottom but it normally comes back, I have a 5.2m quintrex but I do get alot more noise on the screen when the motor is running if I run my power back to my battery instead will this remove all that noise or make it better at least. 

____________________________________________________________________________

 rather be fishing


Posts: 1086

Date Joined: 21/05/12

 i would think s, seeing it

Thu, 2022-03-03 16:43

 i would think s, seeing it only pops up when motor is running

u can get inhttps://www.prelectronics.com/support/pr-knowledge-library/tips-and-tricks/8-tips-and-advice-for-reducing-the-effects-of-emi-on-your-instrumentation-signals/

terference shields - here is some tips on this website

  https://www.prelectronics.com/support/pr-knowledge-library/tips-and-tricks/8-tips-and-advice-for-reducing-the-effects-of-emi-on-your-instrumentation-signals/

easiest way to check 

 connect intruments to another power source - not fed/ charged by motor if it improves it must be engnne noise

still trying's picture

Posts: 1048

Date Joined: 27/06/17

 Thanks for that, I was

Thu, 2022-03-03 17:04

 Thanks for that, I was actually thinking same thing take extra battery out and strap it up front and see what difference it makes. 

____________________________________________________________________________

 rather be fishing

deep south's picture

Posts: 189

Date Joined: 28/12/16

Ferrite

Thu, 2022-03-03 17:11

 Go to Jaycar and get a couple of $7 ferrite cores and put one over the power lead and one over the trany lead

Worked on a jrc unit that was doing the same thing years ago

____________________________________________________________________________

The next time i see that jig will be in the mouth of something big !!

 

still trying's picture

Posts: 1048

Date Joined: 27/06/17

 Thanks for the tip Deep

Fri, 2022-03-04 13:18

 Thanks for the tip Deep South I looked these things up at altronics and they are even cheaper only about 3-4 bucks. Where is the best place to clamp them, I will ask when I buy them but I will probably be talking to a teenager who might not really know. 

____________________________________________________________________________

 rather be fishing

still trying's picture

Posts: 1048

Date Joined: 27/06/17

 I will check it out 

Fri, 2022-03-04 10:11

 I will check it out

 

____________________________________________________________________________

 rather be fishing