Dinghy snap davits
Submitted by davewillo on Mon, 2021-10-11 15:36
Hi all
I'm looking to get a snap davit system installed on my marlin board and new dinghy. These are what you see on a lot of boats so the inflatable dinghy can be clipped on one side and then just lifted on the other side so it's sitting on the edge of the marlin board. I have found where to buy them but want someone to fit everything too. I could probably fumble my way through but if I stuff it up I'd kick myself hard!
Does anyone have suggestions of who might be able to fit these? The supplier doesn't and neither does the Hillary Boat yard who have shipwrights. I'm at a loss and want to get it done when the boat comes out for service in 2 weeks. Any suggestions would be much appreciated.
Cheers
____________________________________________________________________________
PGFC member and lure tragic
Shark1
Posts: 1086
Date Joined: 21/05/12
i ve used halyard
i ve used halyard snapswivels before - u can then also tow on it, but use a secondary safety rope
the design allows u to pull the pin even with a lil bit of load still on it
https://beesactive.com/products/long-buy-3pack-swivel-eye-snap-shackle-quick-release-bail-rigging-sailing-boat-marine-316-stainless-steel-for-sailboat-spinnaker-halyard-2-3-4-silver?variant=39258522353733
davewillo
Posts: 2400
Date Joined: 08/09/16
Thanks Shark1. How do you
Thanks Shark1. How do you actually use them in this situation?
PGFC member and lure tragic
Shark1
Posts: 1086
Date Joined: 21/05/12
ill send u a pm
ill send u a pm