Small piece of 3mm aluminium needed
Submitted by Anytime Brad on Sun, 2020-08-02 11:46
Hi all need a piece of Ideally 3mm thick aluminium With a right angle edge with the minimum dimensions shown. (Can cut it down if larger. Any ideas where I could get this would be welcome.
Cheer Brad
____________________________________________________________________________
I would rather be fishing
Image Upload:
.thumbnail.JPG "Crayfish (tomato) curry")
sea-kem
Posts: 14978
Date Joined: 30/11/09
I can supply you the cut ali
I can supply you the cut ali piece mate but don't have access to a press at the moment.
Love the West!
Marineboy
Posts: 842
Date Joined: 14/03/14
Ally
if you are near Osborne park custom aluminium will sort you out
My spots are so secret even the fish don't know about them !
Shark1
Posts: 1086
Date Joined: 21/05/12
Willie at bullet boats rocko
Willie at bullet boats rocko will do that up in 5 mins
or get the off cut from him or where ever and i ll bend the 90 for u
Anytime Brad
Posts: 237
Date Joined: 20/07/09
Thanks
Thanks all for your inputI will try custom aluminium on Thursday. If I have no luck there then will look at some of the other options.
Cheers Brad
I would rather be fishing