Stainless Tube Fabrication
Submitted by Grant Jones on Wed, 2013-08-21 18:33
I need a stainless tube rack made up for my jetski fishing setup. Can anybody recommend someone in the henderson marine complex area?
Thanks in advance.
petermac
Posts: 2946
Date Joined: 03/03/10
fabrication
try willie at bullet boats in rocky does smicko work with ali and s/s his number is 95927228 good prices and a top bloke and will do smaller jobs other blokes turn their noses up at
Grant Jones
Posts: 91
Date Joined: 17/08/13
Cheers mate, just what I was
Cheers mate, just what I was after.
Notts
Posts: 2
Date Joined: 26/11/11
Try Dror at CSD Design
Try Dror at CSD Design 0407772010. Does nice work.
You can find him on FaceBook as well.
Tosh.
Grant Jones
Posts: 91
Date Joined: 17/08/13
Thanks mate, I will get a
Thanks mate, I will get a quote from him too. Pics on facebook look impressive.
Bluetonic
Posts: 1147
Date Joined: 09/01/08
Plenty of boat building
Plenty of boat building places in Henderson. Just make sure whoever is doing it uses a Argon based gas with at least 1.5% oxygen in it if it is Mig welding and only thin stainless. (Less than 3ml) Otherwise they need to use a gas with Argon base and Helium and CO2 for thicker stainless. For Tig welding then you need a Argon based gas with high levels of Helium.
My point here is any gas with Helium is going to cost you and some workshops will use it when it's not needed on minor small ply jobs as it will do the job still.
Blue Sky, Blue Water, Bluetonic!
Grant Jones
Posts: 91
Date Joined: 17/08/13
Thanks for that advice
Thanks for that advice bluetonic. I will definitely have a chat with whoever takes on the project.
petermac
Posts: 2946
Date Joined: 03/03/10
i know jack about welding
I don't know jack about how to do good welds I am a elect / instro by trade but I do now quality work when I see it and its hard to go past willie,s work at bullet boats
Redchoppa
Posts: 102
Date Joined: 15/07/12
Southern Ocean Stainless
Jason at Southern Ocean Stainless ( 12 Crompton Road, Rocko ) made me up a four leg stainless baitboard to fit over my new outboard and also did some some tube work for a new canopy a few months ago. Great job, listened to what I wanted and I got exactly that. I'll be using him to make some custom snapper racks and an awning in the not to distant future.
Grant Jones
Posts: 91
Date Joined: 17/08/13
Thank you all for the
Thank you all for the recommendations!