daiwa certate
Submitted by Travis p on Mon, 2017-05-01 07:44
i have a daiwa certate newest model and on the weekend i was on a good pinky when the drag went silent i have had a look at the clicker and it seems to be ok but it just wont make any noise when i spin the spool anybody in perth able to fix this or should i send it off to daiwa ?
____________________________________________________________________________
wont catch em sitting at home!
JohnSorrell
Posts: 137
Date Joined: 28/07/09
http://3.bp.blogspot.com/-ZGt
http://3.bp.blogspot.com/-ZGtP_F9NYMM/UnCFuqfeSJI/AAAAAAAAAoc/39HUZkGI0BM/s1600/photo+4.JPG
I have the 2016 model and had problems as well. The aluminum bearing seized to the shaft and the spool lifted above the clicker... ... I removed the little c-clip and removed all the bits on the shaft... washers, bearings, clicker, ect... clean it up and re-install. sometimes you need to use too many spacer washers (the white washers) to align the line on the spool, so you may need to flip the clicker upside down to get it to click again.
Gone Fishing...
Travis p
Posts: 727
Date Joined: 28/07/16
yeah i was gunna
send it in to daiwa but they said they have a 8 to 10 week turn around for the service departments so fuck them haha i found an old daiwa reel in the shed and took out the clicker spring and put it in the certate ...good as new with a 15 min turn around haha
wont catch em sitting at home!
JohnSorrell
Posts: 137
Date Joined: 28/07/09
aha... I was gonna say... it
aha... I was gonna say... it took 9 months for Daiwa to get back to me about my 2014 model certate (sheared gear where the handle screws in)... they were waiting on spare gears for months, and in the end they just agreed to send me a new 2016 model upgrade :)
Was worth the wait as the new model was worth so much more :) hehe
Maybe check if they have a new model :)
Gone Fishing...